GE D20MX - Page 89

CHAPTER 5: CONFIGURING THE SOFTWARE
D20MX INSTRUCTION MANUAL GE INFORMATION 89
For example:
D20M>cl
Found License file (/ram/license.key) - copying
copying file /ram/license.key -> /tffs0/swLicense/license.key
License file copied -- rebooting ....
Batch file If Customer Service sends a batch file (batch.lic), use a SCP (Secure Copy) application, such
as WinSCP, to copy the batch file over the network to the /ram directory on the D20MX.
Alternatively, use the D20M Shell RZ command to download the license file via Z-Modem
through the console port. The RZ command automatically places the file in the /ram
directory.
NOTE
The file must be named batch.lic.
Use the D20M Shell command CL (Copy License) to process the batch file. This command
processes the /ram/batch.lic file, extracting the appropriate license block and creates a
new license file (license.lic). If there are no errors, the D20MX automatically restarts.
NOTE
For the batch file to be processed, a license file must be in place. Use the command swlic-
info to verify a license file is in place.
For example:
D20M>cl
Found Batch file (/ram/batch.lic) - processing
copying file /ram/batch.lic -> /tffs0/swLicense/batch.lic
Batch License Installation '/tffs0/swLicense/batch.lic'
Searching for serial number '526-3003-000001''
License Found in Batch File
copying file /ram/newlicense.key -> /tffs0/swLicense/license.key
Success : Success License file updated