70
K0320 Issue No. 1
Scaled Readings
Except in temperature measure ranges
all readings can be presented in a
number of 5 digits and a sign.
This number could represent an
engineering unit like gallons/hour,
revolutions/minute or any other
relationship. This facility is available
on both measurement and source
functions. The original signal reading
is still displayed in smaller sized digits.
Setting up scaled readings
(linear relationship)
Select SCALE to open the set up
screen. Fill out the high- and low-limits
for the span (preset at 4 and 20 mA in
the milliamp ranges). Fill out both
scale ends for the new scale. Press
EXE to show the working screen.
NOTE:
Scaling in lower ranges only
when auto ranging.
Special Measurement Functions
To Next Page
Loading...
