94
K0320 Issue No. 1
Ramp Mode
The MCX-II can generate automatically
a time linear increasing or decreasing
output signal. Signal limits are free to
set within any of the available output
ranges. Time scales can be set
between 1 and 9999 seconds.
NOTE:
The automatic ramp mode
cannot be used together with the
frequency measurement mode and
the pulse count mode.
OU T PU T
mV
VOLT
T/ C
RTD
mA/ XMT
INPUT
OH M
FREQ.
COUN T ER
BAT TERY
SWITCH
Setting up the ramp mode
Select RAMP and fill out the set-up
screen. The high-end value sets the
maximum output. The low-end value
sets the minimum output. Fill out the
required travel and dwell time in
seconds and press EXE.
Special Output Functions
To Next Page
Loading...
