82
K0320 Issue No. 1
Ohms
Go through the OHM menu and select
either the 0-400 or the 0-2000 Ohms
range and enter the DIRECT mode.
Resistance is simulated across the two
terminals as shown. Connecting a third
or fourth wire adapts the simulation to
3 or 4 wire input. Adjustment
resolution is respectively 0.01 Ohms
and 0.1 Ohms.
Frequency
Pulses are symmetrical square wave
and -70 mV zero based. Frequency is
set by the
and keys or numerical
key-pad. Resolution is 0.1 Volt and
amplitude is default set to 5.0 Volts.
With frequency set at 0 Hz this
function becomes available as a
voltage adjustable and regulated DC
supply. Frequency output can take
loads up to 34 mA at 24 Volts
maximum.
Frequency range 0-100 Hz
Go to pulse DIRECT mode to output any
pulse signal between zero and 100 Hz.
Adjustments are made with 0.01 Hz
resolution.
Output of electrical signals
To Next Page
Loading...
