76
K0320 Issue No. 1
Output of electrical signals
Changing the output level
Use the
and keys to ramp the
output signal manually. Holding the
key down will gradually accelerate
the adjustment speed.
Enter a new output value through the
numerical key-pad and press EXE to
activate the signal at the output
terminals. Entered values outside the
range will prompt the message
OUTSIDE RANGE.
Output mode
In the OUTPUT mode you change both
the output reading and the actual
output at the terminals. Entering a new
value through the numerical key-pad
brings you back into the SET mode.
Test Equipment Depot - 800.517.8431 - 99 Washington Street Melrose, MA 02176
FAX 781.665.0780 - TestEquipmentDepot.com
To Next Page
Loading...
