LOGIQ V3/V5/V5 Expert – Basic Service Manual Index-1
5726264-100 English Rev.8
Index
A
abbrevations, 9-3
acclimate time, 2-3
authorized representative in EU, 1-31
average setup time, 3-3
B
before installation (site preparations), 2-1
Boot Up, 3-20
C
cable inspection
mains cable inspection, 10-14
care and maintenance, 10-1
warnings, 10-3
CE compliance, 1-27
change history, i-1
chapter 1
introduction, 1-1
chassis leakage current test, 10-25
cold or hot
if the unit is very cold or hot, 2-3
compatibility
hardware/software, 9-4
completing the setup, 3-14
compliance, 1-27
configuration, 3-21
connect
ethernet, 3-20
probe, 3-20
USB flash card, 3-20
connections
on the rear panel, 3-20
console environmental requirements, 2-3
console requirements, 2-3
contact information, 1-29
contents in this manual, 1-3
conventions used in book, 1-6
cooling, 2-5
copyrights, i-15
customer assistance, 1-29
phone numbers, 1-30
customer order
verification, 3-13
customer provided prerequisite, 8-5
D
damage in transport, i-12
dangerous procedure warnings, 1-24
data network setup requirements, 2-18
desirable features, 2-15
DICOM network function, 2-18
DICOM setup requirements, 2-19
E
electrical requirements, 2-6
EMI limitations
EMI limitations, 2-9
general requirements, 2-6
site circuit breaker
site circuit breaker, 2-7
site power outlets
site power outlets, 2-6, 2-7
specific requirements for the unit, 2-6
unit power plug
unit power plug, 2-7
electrical safety, 1-22
electrical safety tests, 10-19
electrical specification, 3-16
electromagnetic interference
abatement, 2-10
prevention, 2-10
electrostatic discharge prevention, 1-28
EMC, 1-27
compliance, 1-27
what is EMC?, 1-27
EMI, 1-27
abatement, 2-10
prevention, 2-10
protection, 3-13
environmental specifications for the unit, 2-4
errors, i-13
ESD, 1-27
ESD prevention, 1-28
ethernet
connect, 3-20
external I/O
connections, 3-20
F
facility needs, 2-12
To Next Page
Loading...
Need help?
General
