GE Monitor UV-900 - Check Analogue Out; Check Service Mode

Reference information B
Monitor UV-900 User Manual 18-1120-05 Edition AF 35
Check Analogue Out
The function of the connected chart recorder can be tested.
1 Select main menu Check , press OK .
2 Select sub menu Check Analogue Out , press OK .
3 St art the test by selecting on , press OK . The
test will ramp th e signal on each channel up
to 1 V and then decrease the signal in 10%
steps back to 0 V. The test is run
continuously. Compare the diagram of the
chart recorder with the figure.
4 Stop the test by pressing OK or ESC .
Check Service Mode
Service information relevant to the instrument can be checked. Information
may not be available in all menus.
1 Select main menu Check , turn the selection dial clockwise for next display.
2 Select sub menu Check Service Mode by pressing OK .
3 The service telephone number is displayed. Turn the selection dial
clockwise to view the next display.
4 The service contract number is displayed. Turn the selection dial clockwise
to view the next display.
5 The instrument serial number is displayed. Turn the selection dial
clockwise to view the next display.
6 The instrument name and software version are displayed. Turn the
selection dial clockwise to view the next display.
7 The date of the last service is displayed. Turn the selection dial clockwise
to view the next display.
8 Press OK to test the instrument buzzer.
Press Esc to return to the Check Service Mode menu.
Check Analogue Out
(off) on
1 V
Signal to recorder
0 V
Check Service Mode
Telephone Service
012345678901
Contract Number
012345678901
Serial Number
01234567 YM 012345
Monitor UV-900
V1.06
Date of Maintenance
?
Buzzer Test.