GE Multilin g60

GE Multilin G60 Generator Protection System 3-71
3 HARDWARE 3.5 MANAGED ETHERNET SWITCH MODULES
3
The following popup screen will appear warning that the settings will be lost when the firmware is upgraded.
It is highly recommended that you save the switch settings before upgrading the firmware.
3. After saving the settings file, proceed with the firmware upload by selecting Yes to the above warning.
Another window will open, asking you to point to the location of the firmware file to be uploaded.
4. Select the firmware file to be loaded on to the Switch, and select the Open option.
The following window will pop up, indicating that the firmware file transfer is in progress.
If the firmware load was successful, the following window will appear:
Note
NOTE