3-70 G60 Generator Protection System GE Multilin
3.5 MANAGED ETHERNET SWITCH MODULES 3 HARDWARE
3
3.5.6 UPLOADING G60 SWITCH MODULE FIRMWARE
a) DESCRIPTION
This section describes the process for upgrading firmware on a UR-2S or UR-2T switch module.
There are several ways of updating firmware on a switch module:
• Using the EnerVista UR Setup software.
• Serially using the G60 switch module console port.
• Using FTP or TFTP through the G60 switch module console port.
It is highly recommended to use the EnerVista UR Setup software to upgrade firmware on a G60 switch module.
Firmware upgrades using the serial port, TFTP, and FTP are described in detail in the switch module manual.
b) SELECTING THE PROPER SWITCH FIRMWARE VERSION
The latest switch module firmware is available as a download from the GE Multilin web site. Use the following procedure to
determine the version of firmware currently installed on your switch
1. Log into the switch using the EnerVista web interface.
The default switch login ID is “manager” and the default password is “manager”.
The firmware version installed on the switch will appear on the lower left corner of the screen.
2. Using the EnerVista UR Setup program, select the Settings > Product Setup > Communications > Ethernet Switch
> Firmware Upload menu item.
Version: 2.1 beta
842869A1.CDR
To Next Page
Loading...
