26 MM300 MOTOR MANAGEMENT SYSTEM – QUICKSTART GUIDE
ENERVISTA MM300 SETUP SOFTWARE CHAPTER 2: INSTALLATION
3. Check the Setup Software for the availability of the USB Device on the Device setup
Window. It will automatically reappear on the ‘USB Device’ list as ‘MM300 USB Serial
Emulation (COM #)’ as shown in the image below.
4. If the USB Device is not recognized automatically in the Setup Software, repeat the
same procedure 2 or 3 times until the PC Program recognizes the USB device (and
‘MM300 USB Serial Emulation (COM #)’ reappears in dropdown of ‘USB Device’ list).
To Next Page
Loading...
