28 MM300 MOTOR MANAGEMENT SYSTEM – QUICKSTART GUIDE
ENERVISTA MM300 SETUP SOFTWARE CHAPTER 2: INSTALLATION
8. Select Install the software automatically (Recommended) and press the Next
button.
9. Press Continue Anyway.
10. At the end press Finish.
11. Check in the Setup Software for the availability of the USB Device on the Device setup
Window. Now the device will reappear on the ‘USB Device’ list.
For the current version, the USB driver can not be installed on Windows Vista Operating
System and communication to the Device via the Native USB port is not supported.
Installing the EnerVista MM300 Setup software
After ensuring the minimum requirements indicated earlier, use the following procedure to
install the EnerVista MM300 Setup software from the enclosed GE EnerVista CD.
1. Insert the GE EnerVista CD into your CD-ROM drive.
2. Click the Install Now button and follow the installation instructions to install the no-
charge EnerVista software on the local PC.
3. When installation is complete, start the EnerVista Launchpad application.
To Next Page
Loading...
Need help?
General
