NX-10 Installers manual
169
IO modules can be also triggered by keyfob buttons. This way you can turn on and off some external
device or activate a wireless siren. To do this you must activate the switch output functionality for the
keyfob, and correctly set the event triggering the selected output on the particular IO module. The
following example configures the button 1 on the keyfob (light bulb button), to allow it to toggle the
output 1 on the I/O module 4 ON and OFF.
Note: Output cannot be latched when this functionality is enabled (i.e. RF Receiver 32>Outputs>I/O 4 Output
1>Attributes>Output Latched MUST be set to NO), otherwise after triggering output with the keyfob you will
not be able to switch it off with the keyfob.
1. Navigate with the ½¾ keys to RF Receivers>RF Receiver 32>Inputs and press OK.
2. Scroll to the correct Sensor n (where the keyfob is already programmed) and then select
Keyfob>Keyfob Funct 1 and press OK.
3. Scroll to Switch Output 1 and press OK. The keypad beeps once to accept the change and
returns to Keyfob Funct 1.
4. Navigate with the ½¾ keys to RF Receivers>RF Receiver 32>Outputs and press OK.
5. Scroll to I/O 4 Output 1 and press OK.
6. Select Event>Keyfob Funct 1 and press OK.
7. The keypad beeps once to accept the change and returns to Event.
8. Navigate with the ½¾ keys to I/O 4 Output 1>Time, enter 0 and press OK.
9. The keypad beeps once to accept the change and returns to Time.
10. Navigate with the ½¾ keys to I/O 4 Output 1>Partitions and press OK. Select partition
1 only and press OK.
11. The keypad beeps once to accept the change and returns to Partitions.
12. Navigate with the ½¾ keys to I/O 4 Output 1>Attributes>Output Latched and press OK.
Select No and press OK.
13. The keypad beeps once to accept the change and returns to Output Latched. The Code
Stops Timer option is ignored in this case, so it does not have to be set.
After the siren/IO module is learned-in you need to set up threshold values and turn the
antipassivation feature ON, if necessary. The following example sets the threshold low battery value
to 30 x 0.1 V, threshold low auxillary voltage to 98 x 0.1 V and turns the antipassivation feature ON
for the RF siren/IO module 1.
1. Navigate with the ½¾ keys to RF Receivers>RF Receiver 32>Sirens/IO Features and
press OK.
2. Scroll to RF Siren/IO 1 and press OK.
3. Scroll to Threshold and press OK.
4. Scroll to Low Battery and press OK. Set the low battery threshold to 30 x 0.1 V with the
½¾ keys and press OK. The keypad beeps once to accept the change and returns to Low
Battery.
5. Scroll to Low Aux Voltage and press OK. Set the low auxillary voltage threshold to
98 x 0.1 V with the ½¾ keys and press OK. The keypad beeps once to accept the change
and returns to Low Aux Voltage.
6. Navigate with the ½¾ keys to Sirens/IO Features>RF Siren/IO 1>Antipassivation and
press OK.
To Next Page
Loading...
Need help?
General
