GE NX-10 Installer Manual

NX-10 Installers manual
245
Appendix 1: Reporting codes in Contact ID or SIA
Table 37 Event codes lists the event codes sent for different reports (if enabled) when using Contact
ID or SIA formats. The numb
ers in brackets following the event is the number that is reported as the
zone number. If there are no parentheses, the zone is 0. An asterisk represents the first character from
the event code of the zone that is bypassed or in fault.
Table 37. Event codes
Report
Contact
ID
SIA Report Contact ID SIA
Manual test 601 RX Keypad tamper 137 TA
Autotest 602 RP Keypad panic (audible) 120 PA
Open (user number) 401 OP Keypad panic (silent) 120 PA
Close (user number) 401 CL Duress 121 HA
Cancel (user number) 406 OC Keypad auxiliary 1 110 FA
Start program 627 LB Keypad auxiliary 2 100 MA
End program 628 LX RF sensor lost (zone number) 381 *T
Recent close (user number) 401 CR
RF sensor restore (zone
number)
381 *R
Exit error (user number) 457 EE
Sensor low battery (zone
number)
384 XT
Event log full 605 JL
Sensor battery restore (zone
number)
384 XR
Fail to communicate 354 RT Zone fault (zone number) 380 *T
Expander fault (device
number)
333 ET
Zone fault restore (zone
number)
380 *R
Expander restore (device
number)
333 ER Zone tamper (zone number) 137 TA
Telephone fault 351 LT
Zone tamper restore (zone
number)
137 TR
Telephone restore 351 LR Zone bypass (zone number) 570 *B
Siren tamper (device
number)
321 YA Bypass restore (zone number) 570 *U
Siren restore (device
number)
321 YH Near Alarm (A/B Alarm) 138 BM
Aux power over current
(device number)
312 YP Early open/late close 451 OK

GE NX-10 Specifications

General

Brand	GE
Model	NX-10
Category	Security System
Language	English