NX-10 Installers manual
35
Installing the wireless sensors
Mounting the sensors
1. Select the appropriate location to place the sensor. For recommendations and rules
regarding a correct placement of the particular sensor (motion sensor, door/window,
smoke, etc.), see the sensor manual enclosed with the device you want to install.
2. Fasten the sensor base to the wall.
3. Place the sensor battery in the battery holder.
4. Re-install the sensor board and the cover plate.
Sensor learning-in procedure
In order to guarantee mutual recognition, each installed sensor must be learned-in by the control
panel. This procedure usually requires starting the learn-in mode in the control panel with the menu,
and then tripping the tamper switch in the sensor. For all steps required to program a new sensor, see
the section Programming the wireless detectors on page 163.
To Next Page
Loading...
Need help?
General
