Chapter A4 Programming guidelines
Getting started
This chapter describes a NX-10 installation with the menu driven keypad allowing you to program
the system easily using a menu structure.
Country codes
The NX-10 has the ability to set different “country codes”. Each country code has specific default
settings. When you start your system for the first time (see Powering up the system below) and select
keypad defaults during the initial keypad setup, the respective country code is also set up
automatically for the panel. Once the country code has been selected, it will remain set, even after an
installer reset. When changing the country code during programming, all existing programming will
be cleared to the defaults for that country
.
Note: For a detailed first keypad installation description, see Wireless keypad learning-in procedure on page 28.
The table below lists the default country codes.
Table 5. Country codes
Code Country
0 No country (factory setting)
1 Holland
2 Belgium / Poland
3 Sweden
4 Italy
5 Spain
6 Greece
7 South Africa
8 Israel
9 Spain (PRSGR)
10 Turkey
11 France
17 Turkey Pronet
50 US
For all the countries there are the following default codes:
Table 6. Default codes
User code Installer code Download access code
1234 9713 84800000
Note: Press NO key to clear any incorrectly entered user code or other information.
To Next Page
Loading...
Need help?
General
