GE NX-10 Installer Manual

NX-10 Installers manual
177
Output Location Segment Type Description IO module
2 option Partition
1 hex value X-10 unit code
81
2 hex value X-10 house code
1 dec value Event number
2 dec value Zone / user number
82
3 dec value Time
1 option Special configuration
83
2 option Partition
1 hex value X-10 unit code
5
84
2 hex value X-10 house code
1 dec value Event number
2 dec value Zone / user number
85
3 dec value Time
1 option Special configuration
86
2 option Partition
1 hex value X-10 unit code
6
87
2 hex value X-10 house code
IO module 3
1 dec value Event number
2 dec value Zone / user number
88
3 dec value Time
1 option Special configuration
89
2 option Partition
1 hex value X-10 unit code
7
90
2 hex value X-10 house code
1 dec value Event number
2 dec value Zone / user number
91
3 dec value Time
1 option Special configuration
92
2 option Partition
1 hex value X-10 unit code
8
93
2 hex value X-10 house code
IO module 4
LOCATION 70 - PROGRAMMING THE EVENT, USER/ZONE AND TIME FOR OUTPUT 1 (3
segments, numerical data)
Segment 1 - Event
Selects the event that will trigger the output. See chart below for the specific events that can be
selected.
Segment 2 - Zone/user
Selects the zone or user number necessary to trigger an output. If this location is programmed as a
zero (“0”), any zone or user will activate the output (see also location 68). The zone/user filter is
active only for following events: Burglary Alarm, Fire Alarm, 24h Alarm, Zone Tamper (it filters out

GE NX-10 Specifications

General

Brand	GE
Model	NX-10
Category	Security System
Language	English