GE NX-10 Installer Manual

Report type
Information
required
Menu Option
HomeText Control
When HomeText control is
enabled, you can control your
alarm system by sending SMS
text messages from your
mobile phone.
Note: Set up phone 1 and
then use the SMS
commands to register
more phones
User code User Menu>Users>User n>User Code
Note: In order to be recognized by the system, every HomeText user
must have a valid user code configured in the control panel, otherwise
the system will not accept a command. Any attempt to register, or set
up, a HomeText user without assigned user code will cause sending
the “Unauthorised, access denied” SMS message by the system.
User number NX-7002 Module>Reporting>HomeText>Users>HomeText User
n>System Control>User Number
Enable HomeText
Control
Select NX-7002 Module>Options>HomeText>System Control>Home
Text Control>Enable.
Set up the user
password
Select NX-7002 Module>Reporting>HomeText>Users>HomeText User
n>System Control>Password
The user must
enter a password
before sending a
HomeText
command
Select NX-7002 Module>Options>HomeText>System Control>Password
Always Required>Enable.
Commands are
accepted only
from HomeText
phone numbers.
Select NX-7002 Module>Options>HomeText>System Control>Only
Registered Phones>Enable.
Allow the user to
send HomeText
commands from
a registered
phone only.
Select NX-7002 Module>Reporting>HomeText>Registered Phone
Access>Users n
Note: Only users included on this list are granted rights to send
HomeText commands to the system. Removing a user from this list
suspends all user's rights to send HomeText commands, including Any
Phone Access privileges.
Allow the user to
send HomeText
commands from
any phone.
Select NX-7002 Module>Reporting>HomeText>Any Phone
Access>Users n
Note: Sending a HomeText message from the unregistered phone
requires the following syntax:
[Registered Phone Number] [password] command [values]
TCP/IP network connection GPRS Access Point
Number
Select NX-7002 Module>Options>Network>GPRS APN.
PPP Login Select NX-7002 Module>Options>Network>User ID.
PPP Password Select NX-7002 Module>Options>Network>Password.

GE NX-10 Specifications

General

Brand	GE
Model	NX-10
Category	Security System
Language	English