LOC DESCRIPTION DEFAULT PROGRAMMING DATA
167 SMS service centre address (phone number)
14-14-14-14-14-14-14-14-
14-14-14-14-14-14-14-14-
14-14-14-14-14
168 U/D call-back phone number (for CSD GSM)
14-14-14-14-14-14-14-14-
14-14-14-14-14-14-14-14-
14-14-14-14-14
169 GSM SIM PIN code
10-10-10-10-10-10-10-10
170 GSM operator selection
0-0-0-0-0-0
171 Current GSM operator (read only)
(name of operator)
172 Current GSM RSSI (read only)
99
173 Current GPRS Bit Error Rate % (read only)
99
DEVICE STATUS FLAGS (read only)
Segment 1
1 On = Communication with GSM modem OK
2 On = SIM card PIN is OK
3 On = Logged in to the GSM network
4 On = Sending SMS
5 On = Using GSM audio connection
6 On = Using GSM CSD connection
7 On = Connected to GPRS network
8 On = SIM card PUK code required
Segment 2
1 On = Battery voltage failure
2 On = GSM PSU voltage failure
3 On = Bus voltage failure
4 On = Communication channel failure
5 On = U/D session in progress
6 On = U/D session starting
7 On = Reporting in progress
8 On = Good RSSI Level
Segment 3
1 On = Max reports in 24h limit reached
174
2-8
Reserved
175 GSM modem manufacturer (read only)
(name of manufacturer)
176 GSM modem model (read only)
(name of model)
177 GSM modem software revision (read only)
(software revision)
178 GSM modem serial number (read only)
(serial number)
179-199 Reserved
MISCELLANEOUS FEATURE SELECTION
Segment 1
Reserved
Segment 2
1 On = Enable HomeText Control
2 On = only commands from registered phone numbers are accepted
Off = commands from any phone number are accepted
3 On = A password must be included with the HomeText message
Off = A password only required for HomeText messages from unregistered phone(s)
4 On = Forward unrecognized received SMS messages to the Administrator Phone
5 On = Initiate an up/download session via call-back when audio call is detected
6 On = Enable XSIA reporting for SIA overall media types
7 On = TCP/IP polling time in hours
Off = TCP/IP polling time in minutes
8 Reserved
200
Segment 3
To Next Page
Loading...
Need help?
General
