NX-10 Installers manual
67
Location Term Definition
2.1.3.1.5.3 Dialer Delay A menu option that sets the length of time (in seconds) the
dialer waits before reporting an abortable alarm. If the
system is disarmed during this time, the abortable alarm is
not sent to the central station. The delay can be from 0-255
seconds. A value of 0 means that there is no abort delay.
2.1.3.1.5.4 Listen-in A menu option that sends a report to the central station
indicating that a listen-in session must be started.
In order to use listen-in, a NX-534E listen-in module must
be installed and a microphone must be connected. When
an alarm is generated and reported, the central station can
listen to what is happening on the premises.
Certain protocols (such as SIA, Contact ID and 200Bd FSK)
have ‘listen-in blocks’ that are communicated with the
alarm code and indicate that a listen-in session must be
started.
2.1.3.1.6 Copy Zone Type A menu option that copies the settings for a zone type to a
new zone type.
2.2 Outputs A menu entry that groups options relating to
programmable outputs.
2.2.1 Prog Outputs A menu entry that groups options that configure outputs.
2.2.1.1.1 Event Any occurrence such as system arming, faults and alarms.
A menu option that specifies which event activates an
output.
2.2.1.1.1.1 Alarms A menu option that groups together the alarm events that
can be selected to trigger an output.
2.2.1.1.1.2 Arm/Disarm A menu option that groups the events that can be used to
trigger outputs. The entry is available to make selection of
output events more convenient.
2.2.1.1.1.3 Communications A menu option that groups together the communication
events that can be selected to trigger an output.
2.2.1.1.1.4 Keypads A menu option that groups the keypad events that trigger
an output.
2.2.1.1.1.5 Sirens A menu option that groups together the siren events that
can be selected to trigger an output.
2.2.1.1.1.6 Tamper/Fault A menu option that groups together the tamper and
trouble events that can be selected to trigger an output.
2.2.1.1.1.7 Tests
An Outputs menu option that groups together the test
events that can be selected to trigger an output.
2.2.1.1.2 Time Unit A menu option that specifies whether the outputs are
timed in minutes or seconds.
2.2.1.1.3 Time A menu option that sets the length of time for which an
output is activated. If it is set to 0, the output follows the
event.
To Next Page
Loading...
Need help?
General
