GE NX-10

Location Term Definition
2.4.4.3.3.5 Keypad Tamper A menu entry that groups the report codes sent for the
keypad tamper event.
2.4.4.3.4 Power A menu entry that groups report codes sent to the central
station when power related events occur.
2.4.4.3.4.1 Mains Failure A menu entry that groups the codes used to report a mains
failure event.
2.4.4.3.4.2 Low Battery A menu entry that groups report codes sent to the central
station for a low battery event. A restore report is sent to
the central station when this condition is no longer active.
2.4.4.3.4.3 Aux Overcurrent A menu entry that groups the report codes sent to the
central station when an overcurrent event occurs.
2.4.4.3.5 Tamper/Fault A menu entry that groups together the codes used to
report tamper and fault events to the central station.
2.4.4.3.5.1 Box Tamper A menu entry that groups the report codes sent to the
central station when a box tamper event occurs.
2.4.4.3.5.2 Siren Tamper A menu entry that groups report codes sent to the central
station when a siren tamper has occurred.
2.4.4.3.5.3 Zone Fault A menu entry that groups report codes that are sent to the
central station when a zone fault condition occurs.
2.4.4.3.5.4 Siren Tamper A menu entry that groups report codes sent to the central
station when a siren tamper has occurred.
2.4.4.3.5.5 Phone Line Cut A menu entry that groups the report codes sent when a
phone line is cut.
2.4.4.3.5.6 Expander Fault A menu entry that groups report codes sent to the central
station when an expander fault event occurs.
2.4.4.3.5.7 Fail to Communicate A menu entry that groups the report codes sent to the
central station when a fail to communicate event occurs.
2.4.4.3.6 Miscellaneous A menu entry that groups together the codes used to
report selected other events to the central station.
2.4.4.3.6.1 Log Full A menu entry that groups the report codes sent to the
central station when the event log is full.
2.4.4.3.6.2 Autotest A menu entry that groups the report codes sent to the
central station when an autotest is performed.
2.4.4.3.6.3 Cancel A menu option that enables cancel reporting. A cancel
report is sent to the central station when the system is
disarmed (within the time specified by the dialer delay)
after an alarm.
2.4.4.3.6.4 Recent Closing A menu option that sends a report to the central station if
an alarm occurs within five minutes after the panel has
been armed. The user number that armed the system is
also sent.
2.4.4.3.6.5 Start/End Programming A menu entry that groups the reporting codes sent to the
central station when programming starts, and when the
installer leaves programming mode.