PROTEUS XR/a
GE MEDICAL SYSTEMS Operator Manual
REV 11 DIRECTION 2259724-100
5-11
5-2-4 Procedure Screen
To Name or Change a name of a Procedure:
1. Touch the Name Proc button.
2. Touch the name of the procedure to be changed e.g. Chest PA
3. The screen will change to the keyboard screen.
4. Type in the new name of the procedure.
5. Touch the Done button to exit out of the keyboard.
6. Touch the Edit done button to exit procedure edit.
Illustration 5-9
PROCEDURE SCREEN
Procedure Names can contain a combination of 11 characters or spaces
per line. There are a total of 2 lines per procedure. The name appears
between the brackets above the keyboard as it is typed. The same
keyboard will appear as in the category screen.
To change parameters or technique in a procedure
1. Select procedure of choice (procedure button will be a darker shade
of blue).
2. Select the parameter/technique button to be changed.
3. Change the parameter/technique.
4. Select the save param button.
5. Touch the edit done button.
Note: If the changes to the procedure are the default prameters, touch the
default button then save param. The default parameters are the
protocol that appears on the screen when the user initially touches
a procedure.
FOR TRAINING PURPOSES ONLY!
NOTE: Once downloaded, this document is UNCONTROLLED, and therefore may not be the latest revision. Always confirm revision status against a validated source (ie CDL).
To Next Page
Loading...
Need help?
General
