GE Proteus XR/a User Manual

PROTEUS XR/a
GE MEDICAL SYSTEMS Operator Manual
REV 11 DIRECTION 2259724-100
7-10
7-6-3 Bottom View of the Multileaf Collimator
ILLUSTRATION 7-10
AUTOMATIC COLLIMATOR BOTTOM VIEW
On/Off switch (4) for illumination of
full-field and linear light localizer
Linear LASER light localizer and
switch
Centering cross for positioning
Locking lever for accessories
Linear LASER Light Localizer
The linear LASER light localizer provides the axis mark for longitudinal centering
which is lined up with the centering mark on the handle of the cassette loading
device. The Laser light will disappear if the switch is shut off.
• The linear LASER light localizer for projection of the
centering cross is switched on and off with push button
(4) on the control panel.
- Automatic cutout of this function is affected via an
internal time switch.
LASER Warning Label
The operator should pay his attention to the LASER WARNING as follows.
LASER RADIATION
PEAK POWER 1MW / WAVE LENGHT 540-700 NM / CLASS II LASER
PRODUCT
DO NOT STARE INTO BEAM!
WHEN YOU SWITCH ON THE LINEAR LASER LIGHT LOCALIZER, TAKE
CARE THAT NO PERSON LOOKS DIRECTLY INTO THE LASER TO AVOID
EYE INJURIES OR IMPAIRED VISION.
Centering Cross
• The centering cross is used to display the longitudinal
and transverse axies of the exposure field on the cassette
or directly on the patient.
• The full-field light localizer for projecting the centering
cross is switched on and off with push button (4) on the
control panel.
- Automatic cutout is performed via an internal time
switch.
• The linear and full-field light localizers can not be
switched separately.
WARNING
LASER warning label
FOR TRAINING PURPOSES ONLY!
NOTE: Once downloaded, this document is UNCONTROLLED, and therefore may not be the latest revision. Always confirm revision status against a validated source (ie CDL).

GE Proteus XR/a Specifications

General

Brand	GE
Model	Proteus XR/a
Category	Medical Equipment
Language	English