4-4 SEER Light Ambulatory Recorder/Controller Revision A
2019818-008
SEER Light Connect: Troubleshooting
Troubleshooting
WARNING
LEAKAGE CURRENT—Electrical shock to patient could
result from component failure and lack of power
isolation.
In the event this system is used in the patient vicinity, it
must be configured in such a way that it and all of its
electrically-connected peripheral devices are isolated from
mains power to prevent excessive leakage current to the
patient. This can be accomplished through the use of
isolated mains power, or a medical grade isolation
transformer (in compliance with UL 60601, CAN/CSA
C22.2 No. 601.1, IEC 60601-1) with this system. All non-
medical peripheral devices shall comply with IEC and ISO
safety standards that are relevant to that equipment (i.e.,
IEC 60950, UL 60950).
Use of the SEER Light Connect device in the patient
vicinity requires that these measures are observed.
Software Version
To view the software version of the SEER Light Connect device, click
About in the SEER Light Hookup window.
To Next Page
Loading...
