GE V7768 - Table 1-4 VME System Controller - Switch (S10); Table 1-5 Battery Enable - Switch (S11); Table 1-6 Password Clear;Bios Boot Mode - Switch (S12)

Installation and Setup 23
.
CMOS Password
NOTE
The BIOS has the capability of password protecting casual access to
the unit’s CMOS setup screens. The CMOS Clear jumper allows the
user to clear the password in the case of a forgotten password.
NOTE
The default settings in the tables are in bold.
To clear the CMOS password:
1. Turn off power to the unit.
2. Move switch S12 position 1 to On.
3. Wait approximately 5 seconds.
4. Move switch S12 position 1 to Off.
5. Power up the unit.
When power is reapplied to the unit, the CMOS password will be cleared, and the
CMOS will be set to its defaults.
Table 1-4 VME System Controller - Switch (S10)
Position State Function
1-4 On Force VME controller based on 2-3 state
1-4 Off Enable auto system controller
2-3 On Force system controller (any slot)
2-3 Off Force non-system controller (any slot)
Table 1-5 Battery Enable - Switch (S11)
Position State Function
1-4 On Enable Battery
1-4 Off Disable Battery
2-3 On Factory Use Only
2-3 Off Factory Use Only
Table 1-6 Password Clear/BIOS Boot Mode - Switch (S12)
Position State Function
1-4 Off Normal
1-4 On Clear CMOS/Password
2-3 On Boot with Post Errors
2-3 Off Boot Halt on Post Errors