86 V7768/V7769 Hardware Reference Manual
B.6 Security Setup Menu
The ezPORT setup provides both a Supervisor and a User password. If you use
both passwords, the Supervisor password must be set first.
The system can be configured so that all users must enter a password every time
the system boots or when ezPORT setup is executed, using either the Supervisor
password or User password.
Table B-6 AMI BIOS Security Menu
002.53 (C) Copyright 1985-2002, American Megatrends, Inc.
To reset the security in the case of a forgotten password you must clear the
NVRAM and reconfigure.
Refer to Chapter 1 “Installation and Setup” for how to clear the CMOS password.
BIOS SETUP UTILITY
Main Advanced PCIPnP Boot Security Chipset Exit
Security Settings Install or Change the
password.
←→ Select Screen
↑↓ Select Item
Enter Change
F1 General Help
F10 Save and Exit
ESC Exit
Supervisor Password : Not Installed
User Password : Not Installed
Change Supervisor Password
Change User Password
Clear User Password
Boot Sector Virus Protection [Disabled]
To Next Page
Loading...
