GE V7768 - Pci;Pnp Setup Menu; Table B-4 AMI BIOS Pci;Pnp Menu

84 V7768/V7769 Hardware Reference Manual
B.4 PCI/PnP Setup Menu
Included in this screen is the control of internal peripheral cards, as well as
various interrupts. From this menu, the user can also determine if the system’s
plug-and-play is enabled or disabled.
NOTE
Changes in this screen can cause the system to malfunction. If
problems are noted after changes have been made, reboot the
system and access the BIOS. From the Exit menu select ‘
Load
Failsafe Defaults
’ and reboot the system. If the system failure
prevents access to the BIOS screens, refer to
Chapter 1 “Installation
and Setup” for instructions on clearing the CMOS.
Below is a sample screen of the PCI/PnP menu; options in your system may be
different from those shown.
Table B-4 AMI BIOS PCI/PnP Menu
002.53 (C) Copyright 1985-2002, American Megatrends, Inc.
BIOS SETUP UTILITY
Main Advanced PCIPnP Boot Security Chipset Exit
Advanced PCI/PnP Settings NO: lets the BIOS
configure all the
devices in the system.
YES: lets the
operating system
configure Plug and
Play (PnP) devices not
required for boot if
your system has a Plug
and Play operating
system.
←→ Select Screen
↑↓ Select Item
+- Change Option
F1 General Help
F10 Save and Exit
ESC Exit
WARNING: Setting wrong values in below sections
may cause system to malfunction.
Plug & Play O/S [Yes]
PCI Latency Timer [64]
Allocate IRQ to PCI VGA [Yes]
Palette Snooping [Disabled]
PCI IDE BusMaster [Disabled]
OffBoard PCI/ISA IDE Card [Auto]
IRQ3 [Available]
IRQ4 [Available]
IRQ5 [Available]
IRQ7 [Available]
IRQ9 [Available]
IRQ10 [Available]
IRQ11 [Available]
IRQ14 [Available]