Initial use
Vscan Extend – User Manual 3-23
5721203-100 Rev. D
To restart Vscan Extend
1. Press and hold the Power button.
2. Select Restart to restart the device.
Standby Mode
Vscan Extend enters standby mode when the Power button is
quickly pushed. In this mode, Vscan Extend will not have power
to the probe or any display.
OR
Vscan Extend enters standby mode automatically while in
freeze mode for more than 10 minutes.
Push the Power button again once to resume from standby
mode. The device is ready to scan within a second.
NOTE: When resuming the device from standby mode, a new exam is
created and the previous exam data is lost, if not previously
saved.
Sleep Mode
Vscan Extend enters sleep mode if it continues to be in standby
mode for more than 3 hours.
Push the Power button again to resume from sleep mode. The
device is ready to scan within approximately 5 seconds.
NOTE: When resuming the device from sleep mode, a new exam is
created and the previous exam data is lost, if not previously
saved.
Startup procedure
The approximate time taken for the device from switching on
until the device is ready for normal use is 40 seconds.
To Next Page
Loading...
Need help?
General
