GE Vscan Extend - Initial use; First Time Use Setup; Powering the Device On;Off

Preparing Vscan Extend for Use
3-22 Vscan Extend – User Manual
5721203-100
Rev. D
Initial use
First time use
Before Vscan Extend can be used, the following steps must be
done:
1. Install the battery. (See ‘To insert the battery’ on page 3-20
for more information.)
2. Press the Power button to power on Vscan Extend.
3. Activate Vscan Extend. (See ‘Vscan Extend activation’ on
page 3-24 for more information.)
Power on/off
To power on the Vscan Extend
Press the Power button.
Device boots up and scan screen displays within 45 seconds.
NOTE: The Scan screen displays only when the device has been
activated. See ‘Activation’ on page 3-24 for more information.
To power off the Vscan Extend
1. Press the Power button.
A pop-up displays prompting to Power off OR Restart.
2. Select Power off.