GE XMO2 User Manual

Advanced Programming 7-5
September 2007
SET PRESSURE TYPE
Option
The Set Pressure Type? option is used to specify the pressure
compensation measurement units for the XMO2 (the default is the
generic Pres). See Figure C-7 on page C-7 and proceed as follows:
You may now do one of the following:
• Press [N] as many times as necessary to select another Setup menu
option. Then, press
[Y] and proceed to the appropriate section of
this chapter for instructions.
• Press [N] until you reach the Done? option of the Setup menu, then
press
[Y] to return to the top level of the Advanced Menu.
SET EASY MENU ENTRY
Option
The Set Easy Menu Entry? option is used to enable or disable the
Easy Menu Entry feature. To do so, refer to Figure C-7 on page C-7
and proceed as follows:
You may now do one of the following:
• Press [N] as many times as necessary to select another Setup menu
option. Then, press
[Y] and proceed to the appropriate section of
this chapter for instructions.
• Press [N] until you reach the Done? option of the Setup menu, then
press
[Y] to return to the top level of the Advanced Menu.
ADVANCED MENU
Press [N] until this prompt
appears, then press
[Y] or [Enter].
Set Pressure Type?
Select Pressure Type:
Press [N] to select the desired
units, then press
[Y] or [Enter] to
confirm your selection.
[Pres] mmHg PSIa kPa
ADVANCED MENU
You have now completed the
programming of this submenu.
Set Pressure Type?
ADVANCED MENU
Press [N] until this prompt
appears, then press
[Y] or [Enter].
Set Easy Menu Entry?
Select Easy menu Entry:
Press [N] to select the desired
option, then press
[Y] or [Enter] to
confirm your selection.
[ENABLE] disable
ADVANCED MENU
You have now completed the
programming of this submenu.
Set Pressure Type?

GE XMO2 Specifications

General

Brand	GE
Model	XMO2
Category	Transmitter
Language	English