September 2007
5-12 Basic Programming
RESUME Option The Resume option returns the XMO2 to Operate Mode from
Programming Mode.
Note: This option appears if DriftCal is ON or OFF and if a one- or
two-gas calibration has been selected.
To use the Resume option, press
[N] until the following prompt
appears.
You may now do one of the following:
• Press [N] as many times as necessary to select another Basic Menu
option. Then, press
[Y] and proceed to the appropriate section for
instructions.
• Press [Y] to leave the Basic Menu and return to Operate Mode.
BASIC MENU
.
Resume?
To Next Page
Loading...
