GE XMO2

General Programming 6-35
September 2007
DONE? Option The Done? option returns the XMO2 to the General Menu from the
Calibrate System? submenu.
Note: This menu option always appears.
To use the Done? option, refer to the menu map in Figure C-2 on page
C-2 and press
[N] until the following prompt appears.
You may now do one of the following:
• Press [N] as many times as necessary to select another Calibrate
System? option. Then, press
[Y] and proceed to the appropriate
section for instructions.
• Press [Y] to leave the Calibrate System? submenu and return to the
General Menu.
CALIBRATE SYSTEM
Respond as indicated below.
Done?