September 2007
6-34 General Programming
DriftCal Enabled and One
or Two Gases Selected
The Done? option:
This option is used to exit the DriftCal Handler submenu and return
to the Calibrate System menu. At the next prompt, the following two
responses are available:
• Yes - exit immediately to the main Calibrate System menu
• No - remain in the DriftCal Handler submenu
Note: If you choose to remain in the DriftCal Handler submenu (
[N]
above), the Enable DriftCal? and Select Number of Gases
options are not available to reprogram. To access these
options, you must first return to the Calibrate System menu
(
[Y] above) and then re-enter the DriftCal Handler submenu.
This completes the prompts for the Done? option. Go to the
appropriate section of this chapter, based on the selection made
above, for further programming instructions.
DRIFTCAL MENU
Press [Y] or [Enter] to return to
the Calibrate System menu, or
press
[N] to remain in the
DriftCal Handler submenu.
Done?
To Next Page
Loading...
Need help?
General
