GE XMO2 User Manual

Advanced Programming 7-19
September 2007
DRIFTCAL HANDLER
Option (cont.)
The Set Max Drift/Cal option (cont.):
You may now do one of the following:
• Press [N] as many times as necessary to select another DriftCal
Handler menu option. Then, press
[Y] and proceed to the
appropriate section of this chapter for instructions.
• Press [N] until you reach the Done? option of the DriftCal Handler
menu, then press
[Y] to return to the Calibrate System menu.
The Done option:
The Done? option returns the XMO2 to the Calibrate System menu
from the DriftCal Handler? submenu. To use this option, refer to the
menu map in Figure C-8 on page C-8 and press
[N] until the following
prompt appears.
You may now do one of the following:
• Press [N] as many times as necessary to select another desired
DriftCal Handler? option. Then, press
[Y] and proceed to the
appropriate section for instructions.
• Press [Y] to leave the DriftCal Handler? submenu and return to the
top level of the Calibrate System menu.
Max % Drift per Cal:
To accept the current value, press
[Y] or [Enter]. To change the
current value, use the numeric
keys to enter a new value and
press
[Y] or [Enter] twice.
%F.S. [xx]
DRIFTCAL MENU
Press [N] until this prompt
appears, then press
[Y] or [Enter].
Set Max Drift/Cal?
DRIFTCAL MENU
Respond as indicated below.
Done?

GE XMO2 Specifications

General

Brand	GE
Model	XMO2
Category	Transmitter
Language	English