Tool Intended purpose Material no.
Torque screwdriver Mounting the half-rings/hood T.VIS 408-449
Torque wrench ¼“ (2.5-25 Nm) Mounting the clamp connection 408-424
Torque wrench size 1 (2-10 Nm) Mounting the switch bar --
Plug tool extension size 1+2 Mounting the valve disk 408-456
V-ring insertion tool Mounting the V-rings 229-109.88
Hex key a/f 3 Removing/mounting the half-rings T.VIS 408-121
Philips screwdriver Removing the hood T.VIS 406-125
Open-end plug tool size 1 a/f13 Mounting the switch bar 408-452
Jaw wrench, a/f 10/11 Removing the clamp connection 408-033
Jaw wrench, a/f 12/13 Removing the clamp connection 408-034
Jaw wrench, a/f 13/17
Removing the switch bar / valve disk DN
25
408-036
Jaw wrench, a/f 24/27 408-040
Jaw wrench, ends ground, a/f 17-19 Removing the valve disk 229-119.01
Jaw wrench, ends ground, a/f 21-23 Removing the valve disk 229-119.05
Jaw wrench, ends ground, a/f 22-24 229-119.03
Pick-Set Removing the seals 221-007248
Ring wrench double-open size 21x23 Mounting the lock nut / valve disk 408-412
Adjustable plug tool size 1 (1-27) Mounting the valve disk --
Slotted screwdriver
Removing/mounting the pilot valve
T.VIS
406-102
V
ice support Removing/mounting the V-ring aid 470-001
Socket for wrench ¼" long a/f10 Mounting the clamp connection 407-477
Socket for wrench ¼" a/f13 Mounting the clamp connection 408-425
Tool bit 6.3-PH2 Philips 89 mm Mounting the hood T.VIS 408-459
Tool bit 6.3-size 3 hex. 89 mm Mounting the half-rings T.VIS 408-469
9.3 List of tools - 49 / 104
To Next Page
Loading...
Need help?
General
