Geeetech A10T User Manual

Shenzhen Getech Technology Co.,Ltd
15
(Picture 5-18)
When print PLA, set the target nozzle temperature about 190-210℃. When the temp is stable,
control the extruder filament feeding on LCD screen (“Move axis”), feed until there is molten
material flowing from the nozzle.
Observe the nozzle, if there is no filament stuck and the filament is coming out smoothly, then
stop filament feeding, clear the nozzle with tweezers. See picture (5-19).
(Picture 5-19)

Geeetech A10T Specifications

General

Brand	Geeetech
Model	A10T
Category	3D Printers
Language	English