EasyManuals Logo

Geeetech A10T User Manual

Geeetech A10T
54 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #28 background imageLoading...
Page #28 background image
Shenzhen Getech Technology Co.,Ltd
28
8Software setting
8.1Install driver
Two printing choices for A10T: TF card printing and USB printing.
TF card printing: After leveling, insert the TF card into the slot, and choose a .gcode file to start
printing.
USB printing: Connect the printer and computer with a USB cable to control the printer with
slicing software such as Repetier-Host, Cura, Simplify3D, Slic3r, etc. Because of some unstable
factors such as signal interference, the USB printing prone to fail. So we suggest choosing TF card
printing.
The details of USB printing are as follows:
Firstly, turn on the printer, and connect the printer to computer with a USB cable. Normally, the
computer will automatically search the install driver. The newest communication chip of A10T is
CH340. See picture (8-1).
(Picture 8-1)
If it fails to automatically install the driver in computer, then check whether the driver is installed
successfully or not. Click to choose “My computer>Property>Device manager.
If it shows the exclamation mark as picture below (8-2), then you need manually install the driver.

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Geeetech A10T and is the answer not in the manual?

Geeetech A10T Specifications

General IconGeneral
BrandGeeetech
ModelA10T
Category3D Printers
LanguageEnglish

Related product manuals