Geeetech A10T - 10.3 Filament run-out sensor (Optional); 10.4 3 D touch for auto bed leveling (Optional)

Shenzhen Getech Technology Co.,Ltd
50
10.3Filament run-out sensor (Optional)
Before using this function, please check whether it is turned on or not. Choose
“Control”>”Filament”>“Runout sensors” and after entering the menu, make sure that "Runout
sensors" is "On". See pictures (10-3, 10-4).
(Picture 10-3) (Picture 10-4)
 It will pop up the notification “Err: No Filament” when the filament is run out during
printing and the printer will stop. See picture (10-5).
 Press the extruder handle, remove the remaining filament before loading the new filament.
 When the filament is loaded, use a tweezers to clean the nozzle. Press the knob to enter the
main menu, and choose “Resume print” to re-start the printing. See picture (10-6).
(Picture 10-5) (Picture 10-6)
10.4 3D touch for auto bed leveling (Optional)
This printer supports auto bed leveling. Refer to the link below to know how to install the 3d
touch sensor.
https://www.youtube.com/watch?v=_RtsZDbR2po&t=66s
Visit our official forum
http://www.geeetech.com/forum/