129
4. CONFIGURATION
Acronym Scrolling message Password Description
LINRZ CUSTOM
LINEARIZATION CONFIG
Level 2 Lets you configure the parameters for custom linearization in
32 steps or 4 points.
The submenu is visible only if custom linearization was
enabled in the configuration of the main input or of the
setpoint input.
You can set only one linearization, but it can be assigned to
the main input, the setpoint input, or both.
4.24. LINRZ Submenu – Configuring custom linearization
130
130
130
130
Value of step xx
Parameter
page
Setting mV at
start of scale
Setting mV at
full scale
Setting mV at
temperature of
50°C
STP.xx
MV.STA
MV.FUL
MV.50C
To Next Page
Loading...
