www.gemu-group.com 39 / 71 GEMÜ 1435 ePos
17.1.2 Automatic operation (AUTO)
Automatic operation is the normal operating mode. The initial-
ized positioner reacts to set value changes and adjusts the
valve accordingly.
Keys or have no function in this operating mode.
The current position (x) is shown in the top right of the display
and in the middle is the applied set value signal (w) as a per-
centage.
In the bottom line a help text is shown describing the currently
selected parameter.
Press the key to switch to the SETUP menu.
Press the key again to switch to the Mode parameter.
A: W 50.0 : X 50.0 SETUP MODE Auto
17.1.3 Manual operation (MANUAL)
With manual mode, the valve can be adjusted manually. Press
the and keys to set the desired set value.
Press the key to switch to the SETUP menu.
17.1.4 Pause mode (OFF)
In pause mode, the valve remains in the last position and the
positioner does not react to external signals.
Press the key to switch to the SETUP menu.
17.1.5 Configuration (SETUP)
Various parameter values of the positioner can be changed in
the configuration menu. To reach the configuration menu, the
SETUP parameter must be selected in the working level and
then the key must be pressed.
17.2 Configuration menu (SETUP)
The configuration menu consists of five submenus with the
following functions:
1. Service This menu is used to read out
all information/diagnostics re-
garding the positioner, the
connected signals and errors
that occur.
2. SetBasics SetBasics is used to set the
basic settings for the posi-
tioner such as the initializa-
tion, selection of input signals
and resetting to default set-
tings.
3. SetFunction The special positioner func-
tions are switched on or off
here and the control paramet-
ers are set.
4. SetCalibration SetCalibration is used to set
the directions of action, char-
acteristic curves, stroke lim-
iter and seal adjuster.
5. Communication No function
17 System mode ADVANCED
To Next Page
Loading...
