GEM 1435 ePos - Gemü Conexo; Intended Use

www.gemu-group.com 9 / 71 GEMÜ 1435 ePos
5 GEMÜ CONEXO
Order variant
In the corresponding design with CONEXO, this product has
an RFID chip (1) for electronic identification purposes. The po-
sition of the RFID chip can be seen below. The CONEXO pen
helps read out information stored in the RFID chips. The CON-
EXO app or CONEXO portal is required to display this informa-
tion.
1
For further information please read the operating instructions
for CONEXO products or the CONEXO datasheet.
Products such as the CONEXO app, the CONEXO portal and
the CONEXO pen are not included in the scope of delivery and
need to be ordered separately.
6 Intended use
DANGER
Danger of explosion
▶ Risk of severe injury or death.
● Do not use the product in potentially
explosive zones.
● The product can control valves in po-
tentially explosive areas using special
wiring (installation of the positioner
outside the EX area).
WARNING
Improper use of the product!
▶ Risk of severe injury or death
▶ Manufacturer liability and guarantee will be void
● Only use the product in accordance with the operating
conditions specified in the contract documentation and in
this document.
The product is not intended for use in potentially explosive
areas.
The product with integrated pilot valves is designed for linear
actuators and quarter turn actuators. The product works with
microprocessor controlled intelligent position control by
means of an analogue travel sensor (potentiometer). This is
connected in a force-locking way with the actuator spindle or
shaft by means of a mounting kit (spring, operating bush).
The valve position and the integrated travel sensor can be
monitored via the electrical connections. The pneumatic actu-
ator is directly operated and controlled by means of the pilot
valves.
● Use the product in accordance with the technical data.
6 Intended use