Genelec Loudspeaker Manager (GLM) 4 - System Operating Manual page 16 of 87
4.2.8 Digital Audio 5.1 with a 7300 Series Subwoofer with 9301
Before cabling, turn off the power in all monitors and subwoofers. 7300 series subwoofers have
one (stereo) input for AES/EBU digital audio, and 9301 Multichannel AES/EBU Interface is needed
to expand the connectivity for AES/EBU to the subwoofer. An example of the audio cabling for
AES/EBU digital audio is shown in Figure 8. An example of an AES/EBU digital audio surround
cabling with 7300 series subwoofer and 9301.
Connect the following XLR digital audio cables:
Left/Right channel pair
from the AES/EBU output of the audio source to the 9301’s ‘AES IN 1’ connector
from the 9301’s ‘AES OUT 1’ to the right monitor ‘DIGITAL IN’
from the right monitor ‘DIGITAL OUT’ to left monitor ‘DIGITAL IN’
Surround Left/Right channel pair
from the AES/EBU output of the audio source to the 9301’s ‘AES IN 2’ connector
from the 9301’s ‘AES OUT 2’ to the surround right monitor ‘DIGITAL IN’
from the surround right monitor ‘DIGITAL OUT’ to surround left monitor ‘DIGITAL IN’
Center/LFE channel pair
from the AES/EBU output of the audio source to the 9301’s ‘AES IN 4’ connector
from the 9301’s ‘AES OUT 4’ to the center monitor ‘DIGITAL IN’
Sum signal
from the 9301’s ‘SUBWOOFER LINK’ output to the 7300 series subwoofer ‘DIGITAL IN’
connector
NOTE: The AES/EBU digital input mode in the 73xx subwoofer must be set in ‘Used with
9301’ mode in the Group page. See Digital Input chapter for more details.
To Next Page
Loading...
Need help?
General
