Genelec GLM 4 - The steps to run AutoPhase

Genelec Loudspeaker Manager (GLM) 4 - System Operating Manual page 61 of 87
7.16.2 The steps to run AutoPhase
The steps to run AutoPhase are
 before you start, select the Bass Management Filter frequency (see group settings)
 select the subwoofer to be AutoPhased by clicking on the subwoofer icon
 select the reference monitor by clicking on a monitor icon (the monitor will be highlighted,
and the monitor’s LED will flash)
 click ‘Start Calibration’
 wait until the measurement process completes
 accept the phase setting by clicking ‘Confirm Calibration’