Genelec Loudspeaker Manager (GLM) 4 - System Operating Manual page 53 of 87
Acoustic editor and scoring system for woofer systems chapter)
1)
Input(s) In used : Analog input or the digital audio subframe selected for reproduction
Firmware Version : to view firmware version for each monitor and subwoofer. Firmware
update button enabled if an update available.
1)
All models won’t support the feature and shows ‘Info N/A’ if information type is not supported.
2)
The temperature shown is the temperature of the main microcontroller of the speaker, as reported by the
microcontroller itself. This information is useful for comparison between speakers, for example in a fault situation. The
microcontroller temperature is very local and should be fine up to around 80°C, though in practice it should never reach
such a high temperature.
Monitor data display can be useful in many ways. To give an example, when you have the digital
audio input selected and want to know how much signal is seen by the monitor input.
7.11 Access to Monitor and Subwoofer Acoustic Settings
Access to monitor and subwoofer acoustical calibration and settings is available by right-clicking on
the monitor and subwoofer icons from the GLM Main page.
7.12 Rerunning AutoCal Automatic Calibration
To rerun AutoCal automatic calibration is available from ‘Group Preset : Calibrate’ menu. This
brings up the AutoCal window and starts the calibration process again.
You can rerun the AutoCal automatic calibration
to ensure the calibration is still valid
when there have been significant structural changes in the room (tables or other furniture
have been moved or there has been structural changes to the walls, ceiling, or floor)
when the listening position has changed
when the locations of items close to the monitors or close to the listening position have
changed
It is usually a good idea to take a copy of the current setup file and perform the recalibration in the
copy instead of doing it the original setup file. This retains both and enables evaluation of the
recalibration outcome. You can take a copy of your setup file with the ‘File | Save as…’ menu
command.
7.13 Rerunning AutoPhase Automatic Phase Calibration
To rerun AutoPhase automatic subwoofer phase calibration is available from ‘Group Preset :
Calibrate’ menu. This brings up the AutoCal window, you can confirm the AutoCal settings if
AutoCal already done for the group preset. After AutoCal confirmation the AutoPhase window
opens and the calibration process can be done again.
You can rerun the AutoPhase automatic phase calibration
to ensure the calibration is still valid
To Next Page
Loading...
Need help?
General
