Genelec GLM 4 User Manual

Genelec Loudspeaker Manager (GLM) 4 - System Operating Manual page 59 of 87
7.15.1 MultiPoint calibration
GLM supports unlimited number of microphone positions in the ‘MultiPoint’ mode.
The steps of a MultiPoint calibration are
 select ‘MultiPoint’ in the AutoCal window (additional microphone positions can be measured
after the primary position)
 place the microphone in the primary listening position
 press the ‘Start Calibration’ button to start the measurement and follow the dialogue
instructions – keep on selecting new measurement positions as long as needed, following
the dialogue instructions
 wait until all the measurement sweeps have been completed for all monitors and
subwoofers, the press the ‘Optimize’ button to start the calculation process and wait until
completed
 review the results by clicking on the monitor and subwoofer icons
 continue to AutoPhase when there is a subwoofer in the system – before running the
AutoPhase, move the microphone to the primary (first) microphone position and follow the
dialogue instructions
 continue to WooferCal when there is a W371 woofer in the system – before running the
AutoPhase, move the microphone to the primary (first) microphone position and follow the
dialogue instructions
 accept the calibration result with the ‘Confirm Calibration’ button
Figure 32. Selecting the MultiPoint calibration

Genelec GLM 4 Specifications

General

Brand	Genelec
Model	GLM 4
Category	Speaker System
Language	English