Genelec Loudspeaker Manager (GLM) 4 - System Operating Manual page 36 of 87
In this mode, the two drivers within the W371 unit are measured individually, and the operating
range of each individual unit determined by evaluating the quality of the responses – with the driver
having the best response quality chosen to operate in that range.
The other modes of operation are directivity control modes, where pre-determined filter sets are
recalled that have been designed to make set directivity patterns, based on phase and amplitude
manipulation of the individual units.
Continued directivity mode:
In this mode, a constant horizontal directivity pattern is held as far down in frequency as possible
(in this case to 50Hz). The x-over frequency to the monitor is selected based on the monitor paired,
to ensure a matched directivity pattern.
To Next Page
Loading...
