3-31
03
Rear center seat belt (if equipped)
OJWEV031020 OJWEV031020
1. Take out the buckle (2), which is
stored between the seat/seatback
cushions.
2.
Insert the metal plate (1) into the
buckle (2), until it clicks.
You can make sure its secure
fastening by pulling the seatbelt
webbing. The buckle with ‘CENTER’
mark should be used for the 3-point
seatbelt.
3.
Restore the buckle between the seat/
seatback cushion after unfastening
the seatbelt.
Pre-tensioner seat belt
OJX1039118OJX1039118
[1]: Retractor pre-tensioner seat belt Front seat and
second row outboard seat
Your vehicle is equipped with driver’s and
front passenger’s and rear passengers
Pre-tensioner Seat Belts (Retractor
Pre-tensioner). The purpose of the pre-
tensioner is to make sure the seat belts
fit tightly against the occupant’s body
in certain frontal or side collision(s). The
pre-tensioner seat belts may be activated
in crashes where the frontal or side
collision(s) is severe enough, together
with the air bags or sometimes it activate
alone when wearing a seat belt.
When the vehicle stops suddenly, or if
the occupant tries to lean forward too
quickly, the seat belt retractor will lock
into position.
In certain frontal collisions, the pre-
tensioner will activate and pull the seat
belt into tighter contact against the
occupant’s body.
If the system senses excessive tension
on the driver or passenger’s seat belt
when the pre-tensioner system activates,
the load limiter inside the retractor
pre-tensioner will release some of the
pressure on the affected seat belt (if
equipped with load limiter).
To Next Page
Loading...
