6-22
Driving your vehicle
Automatic engagement of EPB
After the vehicle is stopped by the
One Pedal Driving function, EPB is
automatically engaged when any of
these conditions occur:
•
The driver’s seatbelt is unfastened and
the driver’s door is open.
• The sift gear is changed N (Neutral)
•
The hood is open.
•
The tailgate is open.
•
5 minutes have passed after the
vehicle has stopped.
•
The system operation is limited due to
other reasons.
WARNING
• Stopping the vehicle may not be
possible according to the vehicle and
road conditions. Pay attention to the
road condition ahead and apply the
brake if necessary.
•
Please refrain to use the one pedal
driving function with the road
conditions are bad such as being
wet, iced or covered with snow.
CAUTION
When the vehicle is stopped or parked
by One Pedal Driving on the steep hills,
be sure to depress the brake pedal.
i-Pedal
i-Pedal is controlled by acceleration
pedal. i-Pedal provides vehicle speed
control (acceleration/deceleration,
stopping) without manually controlling
the paddle shifter.
To operate:
•
Pull the left side paddle shifter to level
3 regenerative braking system.
•
The vehicle is stopped by pulling the
left shift lever when the vehicle speed
is less than 3 km/h (1 mph), the vehicle
is stopped even if the left paddle shift
lever is released.
•
When you press the accelerator pedal
at the same time during one-pedal
driving by pulling the left paddle shift
lever, it cannot adjust the vehicle's
speed and stop position.
CAUTION
When the vehicle is stopped or parked
by i-Pedal on the steep hills, be sure to
depress the brake pedal.
To Next Page
Loading...
