Genesis GV60 - Recalling Memory Positions; Resetting the System

5-49
05
Recalling memory positions
1. Shift to P (Park) while the Start/Stop
button is in the ON position.
2.
Press the desired memory button (1
or 2). The system will beep once, and
then the driver’s seat position, outside
rearview mirror position, steering
wheel position and head-up display
height will automatically adjust to the
stored positions.
3.
‘Settings 1(or 2) applied’ will appear on
the cluster display.
Information
• In order to adjust the memory button
(2) while adjusting the memory button
(1), press the memory button (1) to
pause the adjustment of (1), then press
memory button (2).
•
If you adjust the seat, rearview mirror,
steering wheel or head-up display while
recalling the stored positions, the pre-
set settings will become ineffective.
Resetting the system
Take the following procedures to reset
integrated memory system, when it does
not operate properly.
Resetting integrated memory
system
1. Stop the vehicle and open the driver’s
door with the Start/Stop button in the
ON position and the vehicle shifted to
P (Park).
2.
Adjust the driver’s seat and seatback
to the foremost position.
3.
Press the SET button and push
forward the driver’s seat movement
switch over 2 seconds simultaneously.
While resetting integrated memory
system
1. Resetting starts with a notification
sound.
2.
The driver’s seat and seatback is
adjusted to the rearward position with
the notification sound.
3.
The driver’s seat and seatback is
re-adjusted to the default position
(central position) with the notification
sound.
However, in the following cases, the
resetting procedure and the notification
sound may stop.
•
The memory button is pressed.
•
The seat control switch is operated.
•
The gear is shifted out of P (Park).
•
The driving speed exceeds 3 km/h
(2 mph).
•
The driver’s door is closed.