9-47
09
Headlamp, position lamp, turn
signal lamp, Daytime Running
Light (DRL) replacement
OJWEV091014 OJWEV091014
(1) Headlamp (Low)
(2)
Headlamp (High / Sub low)
(3)
Position lamp/Daytime running light/
Turn signal lamp
If the LED lamp does not operate,
we recommend that the system be
inspected by an authorized retailer of
Genesis Branded products.
The LED lamps cannot be replaced as
a single unit because it is an integrated
unit. The LED lamps has to be replaced
with the unit.
A skilled technician should check or
repair the LED lamp, for it may damage
related parts of the vehicle.
Headlamp aiming
OJWEV091040LOJWEV091040L
[A] : Low beam and high beam vertical aiming
[B] : Low beam and high beam horizontal aiming
1. Inflate the tires to the specified
pressure and remove any loads from
the vehicle except the driver, spare
tire, and tools.
2.
The vehicle should be placed on a flat
floor.
3.
Draw vertical lines (Vertical lines
passing through respective head
lamp centers) and a horizontal line
(Horizontal line passing through
center of head lamps) on the screen.
4.
With the headlamp and battery in
normal condition, aim the headlamps
so the brightest portion falls on the
horizontal and vertical lines.
5.
To aim the low beam and high beam
left or right, turn the driver clockwise
or counterclockwise.
To aim the low beam and high beam
up or down, turn the driver clockwise
or counterclockwise.
To Next Page
Loading...
