5-60
Convenience features
Reverse parking aid user settings
mode
You may change the angle of the outside
rearview mirror if it is difficult to see
the rear view with the basic downward
mirror angle provided when reversing.
When the vehicle is first delivered, the
set downward angle of the left and right
outside rearview mirror are different to
ensure driver visibility.
1.
Make sure the vehicle is stopped.
2.
Depress the brake pedal and shift the
gear to R (Reverse). When L (Left) or R
(Right) button is pressed, both outside
rearview mirror angle will move
downward to the basic set position.
3.
Press either L or R button to select the
outside rearview mirror you would like
to adjust. Then press “▼, ▲, ◄, ►”
switch to adjust the outside rearview
mirror to the desired angle.
4.
After adjusting the angle to save the
adjusted outside rearview mirror
angle, shift the gear to another
position other than R (Reverse), or
change the L and R buttons to the
neutral position (L and R buttons are
not pressed).
5.
Set the other outside rearview mirror
following the above procedure 1 to 4.
Resetting reverse parking aid user settings
mode
To change the outside rearview mirror
angle back to the basic angle, shift the
gear to R (Reverse), and adjust the mirror
angle higher than when the gear is in P
(Park), N (Neutral) and D (Drive).
NOTICE
When changing the angle of both
outside rearview mirrors, it is
recommended to change the angle one
side at a time following the procedure
1 to 4.
To Next Page
Loading...
